It's looking good so far ... I think.
The head mold is a little tricky because it consists of three parts.
I chose to do it that way, because then the parting lines will run over the border of the hair, instead of through the middle of her face.
This way the clean up work after casting, becomes a little easier.( I hope.)
There probably is an easier way or technique to make that mold, but I'm not aware of it ... yet, and I never made one before, so it's a nice experiment.
Hopefully it will come out right. I believe it will work.
Fingers crossed, ... a little bit.
Listening to: Josh Rouse (again :-)
No comments:
Post a Comment